Con Edison
THE CLEARANCES PROVIDED APPLY TO DISTRIBUTION LINES UP TO 33KV ONLY. IF WORK IS TO BE PERFORMED AROUND TRANSMISSION LINES, PLEASE REFER TO THE GUIDELINES
Get QuoteRelated Topics:
Distance Between Suspended Platform
SECTION 7
The front edge of all platforms shall not be more than 14 in (36 cm) from the face of the work, unless guardrail systems are erected along the front edge and/or personal fall arrest systems are...
Get Quote
Equipment Location and Clearances
In addition to the 36-inch dimension (914 mm), the work space shall not be less than 30 inches (762 mm) wide in front of the electrical equipment and not less than the width of such equipment.
Get Quote
Part 12 Scaffolds and Scaffold Platforms
•Each platform unit shall be installed so that the space between adjacent units and the space between the platform and the uprights is no more than one inch wide, except where the employer can
Get Quote
eTool : Scaffolding
Suspended scaffolds are platforms suspended by ropes, or other non-rigid means, from an overhead structure. Because two-point scaffolds are the most common type of suspended scaffold, this eTool
Get Quote
Minimum Approach Distance Chart
The minimum approach distance chart defines safe working distances to prevent arc flash injuries. Based on NFPA 70E and OSHA standards, it helps protect electrical workers by specifying limits by
Get Quote
Electrical Panel & Gear Clearance Guide | NEC 2023
Depth: A minimum of 3 feet (900 mm) in front of the electrical panel for installations up to 600V. Width: The width of the equipment or panel door plus 30 inches (760 mm), whichever is
Get Quote
Safe Clearances for Electrical Equipment: Working Space and
Side clearance: There should be a minimum of 30 inches of clearance from the sides of all electrical equipment, but in no case less than the width of the equipment itself. This is referred to as the side-to
Get Quote
NEC Working Clearance Requirements: A Visual Guide (110.26)
Per NEC 110.26 (D), all working spaces must have a minimum Electrical equipment headroom of 2.0 m (6 ft 6 in), measured from the floor or platform to the ceiling or any overhead obstruction like pipes or
Get Quote
Working Clearances, based on the 2020 NEC
The height of the working space must be clear and extend from the grade, floor, or platform to a height of 6½ ft or the height of the equipment, whichever is greater [110. 26 (A) (3)].
Get Quote